Home > Knowledge > Content

How to properly clean the filter

Apr 30, 2019

1. First brush the surface leaves and dust with a soft brush.

The first is to use a soft brush to brush off the leaves and dust on the surface, and then use an air gun to blow.

The air pressure of the air gun should not be too high, generally only between 0.2 and 0.3 MPa, 2 to 3 bar written in the native language, or kilogram.

2. It is best to use a special dust gun to blow the filter

In the air gun in the general repair shop, the pressure at the muzzle is above 7 bar, and the filter element will be blown off.

Therefore, it is best to use a special dust gun to gently blow, there is no such thing, far away blowing, do not stick directly to the filter so dry.

3. To blow against the opposite side of the filter

Secondly, it is necessary to blow against the reverse side of the filter element. This part of the dust particles passes through the filter element due to the front side blowing.

Some silica, a relatively hard material composed of particles, may scratch the pores of the filter, causing it to break.www.inocofiltration.com