Home > Knowledge > Content

Model selection and equipment installation of stainless steel cartridge filter

Aug 13, 2018

The filter element in the stainless steel cartridge filter is widely used, and the variety and specifications of the filter are numerous, so it is important to select the model. According to the use, it can be divided into two kinds of filtering liquid and gas. The size can be divided into 5, 10, 20, 30and 40; the working pressure is generally 0.1Mpa-0.4Mpa.


Due to the different pore size of the stainless steel cartridge filter, the flow rate is not the same. For example, the standard of 0.2um-0.4 um filter water is 300-500kg/h. If you want to increase the filtration volume per hour, you can use multi-core. Or 20 , 30 , 40 inch combination, if the filter impurities and viscosity, then add pre-filter equipment.


Although the stainless steel cartridge filter is equipped with filter elements with different pore diameters, in order to achieve the purpose of fine filtration, pre-filtering equipment must be used in the early stage, and the microporous filter core is used. It is also important to install and use the stainless steel cartridge filter.


Before installing the stainless steel cartridge filter, look at the clearing and exiting direction. The liquid should flow from the outside of the filter to the center. The pipe that communicates with the filter insert is the outlet. If it is a multi-core, the pressure plate should be placed on the fins, and the bolts should be properly tightened; the outer cover should be installed and sealed with the clamps or bolts on the base. Note that the seals should be placed flat and the seals should be checked for no leakage.http://www.inocofiltration.com/